Resource Type

Journal Article 246

Year

2024 2

2023 15

2022 25

2021 16

2020 16

2019 10

2018 12

2017 12

2016 9

2015 11

2014 15

2013 7

2012 9

2011 8

2010 7

2009 14

2008 14

2007 14

2006 4

2005 6

open ︾

Keywords

phase change material 4

1 2

China 2

Crystal structure 2

Phase noise 2

amorphous phase 2

benzene 2

function 2

heat transfer 2

management 2

phase diagram 2

phase inversion 2

phase separation 2

phase transition 2

polyvinylidene fluoride 2

self-assembly 2

thermal energy storage 2

two-phase 2

(−)-epigallocatechin gallate 1

open ︾

Search scope:

排序: Display mode:

Design and simulation of a standing wave oscillator based PLL

Wei ZHANG,You-de HU,Li-rong ZHENG

Frontiers of Information Technology & Electronic Engineering 2016, Volume 17, Issue 3,   Pages 258-264 doi: 10.1631/FITEE.1500210

Abstract: Based on the frequency tunable SWO, a new phase locked loop (PLL) architecture is presented.This PLL can be used not only as a clock source, but also as a clock distribution network to provideThe PLL achieves an approximately 50% frequency tuning range when designed in Global Foundry 65 nm 1P9M

Keywords: Standing wave oscillator (SWO)     Clock distribution     Phase locked loop (PLL)     Varactor    

Improvement of the cascading closed loop cycle system

ZHANG Guoqiang, CAI Ruixian

Frontiers in Energy 2007, Volume 1, Issue 3,   Pages 341-346 doi: 10.1007/s11708-007-0051-5

Abstract: Aspen Plus was used to simulate and get more information about the cascading closed loop cycle (CCLC)

Design and analysis of partially decoupled translational parallel mechanisms with single-loop structures

Frontiers of Mechanical Engineering 2022, Volume 17, Issue 3, doi: 10.1007/s11465-022-0695-1

Abstract: This study presents a family of novel translational parallel mechanisms (TPMs) with single-loop topological

Keywords: translational parallel mechanism     single loop     multiple driving system     workspace analysis     singularity    

Development of a hydrodynamic model and the corresponding virtual software for dual-loop circulating

Shanwei Hu, Xinhua Liu

Frontiers of Chemical Science and Engineering 2021, Volume 15, Issue 3,   Pages 579-590 doi: 10.1007/s11705-020-1953-6

Abstract: Dual-loop circulating fluidized bed (CFB) reactors have been widely applied in industry because of theirThis article proposed a general method for modeling multi-loop CFB systems by utilizing the energy minimizationA full-loop modeling scheme was implemented by using the EMMS model and/or its extension models to computeparameters of the sub-reactors, to achieve the mass conservation and pressure balance in each circulation loopsoftware was further developed to facilitate the flexible creation and fast modeling of a customized multi-loop

Keywords: multi-loop circulating fluidized bed     mathematical modeling     energy minimization multiscale     virtual fluidization    

Loop theory and applications to some key problems of kinematic structure of kinematic chains

Huafeng DING, Zhen HUANG

Frontiers of Mechanical Engineering 2009, Volume 4, Issue 3,   Pages 276-283 doi: 10.1007/s11465-009-0061-6

Abstract: In this paper, a new loop theory of kinematic chains is proposed.

Keywords: Loop theory     kinematic chains     isomorphism     atlas database    

UPFC setting to avoid active power flow loop considering wind power uncertainty

Shenghu LI, Ting WANG

Frontiers in Energy 2023, Volume 17, Issue 1,   Pages 165-175 doi: 10.1007/s11708-020-0686-z

Abstract: The active power loop flow (APLF) may be caused by impropriate network configuration, impropriate parametercontrollers, e.g., the unified power flow controller (UPFC), may be the reason and the solution to the loop

Keywords: active power loop flow (APLF)     unified power flow controller (UPFC)     wind power uncertainty     interval power    

Experimental investigations on operating characteristics of a closed loop pulsating heat pipe

Yu WANG

Frontiers in Energy 2015, Volume 9, Issue 2,   Pages 134-141 doi: 10.1007/s11708-015-0354-x

Abstract: A series of experiments were conducted on a closed loop PHP with 5 turns made of copper capillary tube

Keywords: closed loop pulsating heat pipe     thermal performance     operation limit     thermography    

combined modulated feedback and temperature compensation approach to improve bias drift of a closed-loop

Ming-jun MA,Zhong-he JIN,Hui-jie ZHU

Frontiers of Information Technology & Electronic Engineering 2015, Volume 16, Issue 6,   Pages 497-510 doi: 10.1631/FITEE.1400349

Abstract: In this paper, a combined approach on closed-loop architecture modification is proposed to minimize theThen a common mode signal is created and added into the closed loop on the basis of modulated feedbackThe combined approach could be useful for many other closed-loop accelerometers.

Keywords: Bias drift     Closed-loop MEMS accelerometer     Modulated feedback approach     Temperature compensation    

Analysis and design of transformer-based CMOS ultra-wideband millimeter-wave circuits for wireless applications: a review Review Articles

Yi-ming YU, Kai KANG

Frontiers of Information Technology & Electronic Engineering 2020, Volume 21, Issue 1,   Pages 97-115 doi: 10.1631/FITEE.1900491

Abstract: injection-current-boosting tech-nique which can significantly increase the locking range of mm-Wave injection-lockedBased on the injection- locked principle, we also discuss an ultra-wideband mm-Wave divider with the

Keywords: CMOS     Millimeter-wave (mm-Wave)     Ultra-wideband     Transformer     Low-noise amplifier     Injection-locked fre-quencytripler     Injection-locked frequency divider     Mixer    

Structural parameter design method for a fast-steering mirror based on a closed-loop bandwidth

Guozhen CHEN, Pinkuan LIU, Han DING

Frontiers of Mechanical Engineering 2020, Volume 15, Issue 1,   Pages 55-65 doi: 10.1007/s11465-019-0545-y

Abstract: parameter design approach for an FSM system based on the quantitative analysis of the required closed-loopFirst, the open-loop transfer function of the FSM system is derived.function, the notch filter and proportional-integral (PI) feedback controller are designed as a closed-loopThe gains of the PI controller are determined by maximizing the closed-loop bandwidth while ensuringThen, the two unknown variables of rotational radius and stiffness in the open-loop transfer function

Keywords: fast-steering mirror     structural parameter     PI controller     bandwidth     notch filter    

Wide-range tracking technique for process-variation-robust clock and data recovery applications Article

Jun-sheng LV, You LI, Yu-mei ZHOU, Jian-zhong ZHAO, Hai-hua SHEN, Feng ZHANG

Frontiers of Information Technology & Electronic Engineering 2017, Volume 18, Issue 5,   Pages 729-737 doi: 10.1631/FITEE.1500410

Abstract: A wide-range tracking technique for clock and data recovery (CDR) circuit is presented. Compared to the traditional technique, a digital CDR controller with calibration is adopted to extend the tracking range. Because of the use of digital circuits in the design, CDR is not sensitive to process and power supply variations. To verify the technique, the whole CDR circuit is implemented using 65-nm CMOS technology. Measurements show that the tracking range of CDR is greater than ±6×10 at 5 Gb/s. The receiver has good jitter tolerance performance and achieves a bit error rate of<10 . The re-timed and re-multiplexed serial data has a root-mean-square jitter of 6.7 ps.

Keywords: Clock and data recovery     Digital loop filter     Phase interpolator    

quantification of 3′-terminal 2′-O-methylated small RNAs by utilizing oxidative deep sequencing and stem-loop

Frontiers of Medicine 2022, Volume 16, Issue 2,   Pages 240-250 doi: 10.1007/s11684-021-0909-7

Abstract: We further compared the efficiency of stem-loop and poly(A)-tailed RT-qPCR in quantifying plant miRNAsin animal tissues and identified stem-loop RT-qPCR as the only suitable approach.Likewise, stem-loop RT-qPCR was superior to poly(A)-tailed RT-qPCR in quantifying 3′-terminal 2′-O-methyl

Keywords: small RNAs     2′-O-methylation     sequencing     RT-qPCR    

Simulation of long-term nutrient removal in a full-scale closed-loop bioreactor for sewage treatment:

Zheng LI,Rong QI,Wei AN,Takashi MINO,Tadashi SHOJI,Willy VERSTRAETE,Jian GU,Shengtao LI,Shiwei XU,Min YANG

Frontiers of Environmental Science & Engineering 2015, Volume 9, Issue 3,   Pages 534-544 doi: 10.1007/s11783-014-0660-2

Abstract: In this study, the performance of nitrogen and phosphorus removal in a full-scale closed-loop bioreactor

Keywords: activated sludge model     Bayesian inference     biological nutrient removal     closed-loop bioreactor     oxidation    

system for industrial robots: A CPS-based hybrid architecture for smart assembly shop floors with closed-loop

Qingmeng TAN, Yifei TONG, Shaofeng WU, Dongbo LI

Frontiers of Mechanical Engineering 2020, Volume 15, Issue 1,   Pages 1-11 doi: 10.1007/s11465-019-0563-9

Abstract: industrial robots, this study proposed a hybrid architecture for smart assembly shop floors with closed-loop

Keywords: cyber physical system     robot assembly     multiagent system     architecture    

Microfluidic production of liposomes through liquid–liquid phase separation in ternary droplets

Frontiers of Chemical Science and Engineering 2022, Volume 16, Issue 6,   Pages 1017-1022 doi: 10.1007/s11705-021-2118-y

Abstract: For demonstration, we used butyl acetate-water-ethanol ternary mixtures as inner phase and an aqueoussolution of surfactants as outer phase to make oil-in-water droplets, which can evolve into water-in-oil-in-waterdouble emulsion droplets by liquid–liquid phase separation of ternary mixtures.

Keywords: microfluidics     liposomes     ternary droplets     phase separation    

Title Author Date Type Operation

Design and simulation of a standing wave oscillator based PLL

Wei ZHANG,You-de HU,Li-rong ZHENG

Journal Article

Improvement of the cascading closed loop cycle system

ZHANG Guoqiang, CAI Ruixian

Journal Article

Design and analysis of partially decoupled translational parallel mechanisms with single-loop structures

Journal Article

Development of a hydrodynamic model and the corresponding virtual software for dual-loop circulating

Shanwei Hu, Xinhua Liu

Journal Article

Loop theory and applications to some key problems of kinematic structure of kinematic chains

Huafeng DING, Zhen HUANG

Journal Article

UPFC setting to avoid active power flow loop considering wind power uncertainty

Shenghu LI, Ting WANG

Journal Article

Experimental investigations on operating characteristics of a closed loop pulsating heat pipe

Yu WANG

Journal Article

combined modulated feedback and temperature compensation approach to improve bias drift of a closed-loop

Ming-jun MA,Zhong-he JIN,Hui-jie ZHU

Journal Article

Analysis and design of transformer-based CMOS ultra-wideband millimeter-wave circuits for wireless applications: a review

Yi-ming YU, Kai KANG

Journal Article

Structural parameter design method for a fast-steering mirror based on a closed-loop bandwidth

Guozhen CHEN, Pinkuan LIU, Han DING

Journal Article

Wide-range tracking technique for process-variation-robust clock and data recovery applications

Jun-sheng LV, You LI, Yu-mei ZHOU, Jian-zhong ZHAO, Hai-hua SHEN, Feng ZHANG

Journal Article

quantification of 3′-terminal 2′-O-methylated small RNAs by utilizing oxidative deep sequencing and stem-loop

Journal Article

Simulation of long-term nutrient removal in a full-scale closed-loop bioreactor for sewage treatment:

Zheng LI,Rong QI,Wei AN,Takashi MINO,Tadashi SHOJI,Willy VERSTRAETE,Jian GU,Shengtao LI,Shiwei XU,Min YANG

Journal Article

system for industrial robots: A CPS-based hybrid architecture for smart assembly shop floors with closed-loop

Qingmeng TAN, Yifei TONG, Shaofeng WU, Dongbo LI

Journal Article

Microfluidic production of liposomes through liquid–liquid phase separation in ternary droplets

Journal Article